DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces
must be clean, dry and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using
abrasives or sandpaper). 4. OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up
and pull plunger back slightly (1/8″). Allow air bubbles to rise to top. Snap off and save storage
cap. Push plunger to dispense equal amounts of hardener and resin onto discard-able surface
such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger to
stop flow. Snap cap back on. 5. MIX QUICKLY: Quickly and thoroughly mix until blue color
turns clear (about 15 sec). 6. APPLICATION: Apply small amount of mixture to both surfaces
and assemble parts immediately (product sets in approximately 60 seconds). Remove any
excess epoxy immediately. 7. CURE TIME: Usable strength is reached in 1 hour at 72°F (22°C).
Cooler temperatures may require longer set time. 8. CLEAN-UP: Attach nozzle cap and store in
molded tray. NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
1General purpose epoxy with non-drip gel formula for mess free application
2Blue dye indicator disappears when epoxy is ready to apply
3Permanent strength up to 2,500 PSI strength
4Dries clear and no clamping required
5Water resistant, non-shrinking formula
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
