DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces
must be clean, dry and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using abrasives
or sandpaper) 4. OPEN PACKAGE: Remove tubes and use the back of cap or a sharp point to puncture
seals. 5. DISPENSE: Squeeze tubes to dispense resin and hardener. Thoroughly mix resin & hardener
on a clean, discardable surface for 2 to 3 minutes until evenly colored. 6. APPLICATION: Apply a small
amount of mixture to both surfaces and assemble parts immediately (product sets in 4-6 minutes).
Remove any excess epoxy immediately. 7. CURE TIME: Usable strength is reached in four hours at
72°F (22°C). Cooler temperatures may require longer set time. 8. CLEAN-UP: Attach nozzle caps and
store in molded tray. NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
1General purpose epoxy; two part adhesive and filler system
2Dries clear
3Water resistant, non-shrinking formula
4Temperature Range: -60°F to 180°F (-51°C to 82°C)
5Permanent strength up to 3400 PSI
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
