DIRECTIONS: 1. For best results: Roughen, remove any grease and oil, clean and dry surfaces to be joined or repaired. 2. Remove plastic mixing paddle from center of black plunger. Turn nozzle end up and pull plunger back slightly (1/8″). Allow air bubbles to rise to top. Snap off and save storage cap. 3. Push plunger evenly to dispense equal amounts of hardener and resin onto a discardable surface such as a piece of cardboard or the plastic container on the front of this package. Pull back plunger to stop flow. 4. MIX THOROUGHLY with paddle provided. Epoxy has a working time of 10 minutes. 5. Apply to surfaces to be
joined or repaired. Epoxy will fixture in 2 hours and fully cure in 24 hours. Wipe nozzle clean. Replace cap for storage. NOTE: Will not bond to polyethylene or polypropylene plastics
1High heat resistant up to 500°F (260°C).
2Seals against many liquids, gasses and common automotive fluids
3Ideal for under hood automotive applications
4Permanent strength up to 2500 PSI
5Sets in 10 minutes, cures in 2 hours
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
