DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces must be clean, dry
and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper). 4. OPEN
PACKAGE: Remove tubes and use a sharp point to puncture seals. 5. DISPENSE: Squeeze tubes to dispense resin and
hardener. Thoroughly mix resin & hardener on a clean, discardable surface for 2 to 3 minutes until evenly colored.
6. APPLICATION: Apply a small amount of mixture to both surfaces and assemble parts immediately (working time is
approximately 4-6 min.). Remove any excess epoxy immediately. 7. CURE TIME: Usable strength is reached in four
hours at 72°F (22°C). Cooler temperatures may require longer set time. 8. CLEAN-UP: Attach nozzle caps and store in
molded tray. NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
1Multi-metal epoxy; two part adhesive and filler system
2Dries dark grey
3Permanent strength up to 4500 PSI
4Can be drilled, filed and threaded
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
