TO MAKE A GASKET: 1. Clean both flange surfaces. Remove paint,
dirt, grease or old gasket completely. 2. Spray Permatex Surface
Prep® Activator on one surface only. Allow to dry 1-2 minutes. 3. Apply
a continuous bead of sealant to the unprimed surface. 4. Assemble
mating surfaces with minimal lateral movement. Excess sealant can
be wiped away with a cloth.
TO DRESS A GASKET: 1. Clean both flange surfaces. Remove paint,
dirt, grease or old gasket completely. 2. Spray Permatex Surface
Prep® Activator onto both flange surfaces. Allow to dry 1-2 minutes.
3. Completely cover both sides of the pre-cut gasket with sealant.
4. Place coated gasket on flange and assemble mating surfaces with
minimal lateral movement.
1For use on rigid machined flanges with less than .015" gap
2OEM approved for use where anaerobic gasket is specified
3Eliminates preformed, pre-cut, paper, rubber and cork gaskets
4Flexes with flanges that move in service
5Withstands temperatures to 300°F (149°C)
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
