TO MAKE A GASKET: 1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely. 2. Spray Permatex Surface Prep® activator on one surface only. Allow to dry 1-2 minutes. 3. Apply a continuous bead of sealant to the unprimed surface. 4. Assemble mating surfaces with minimal lateral movement. Excess sealant can be wiped away with a cloth. TO DRESS A GASKET: 1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely. 2. Spray Permatex Surface Prep® activator onto both flange surfaces. Allow to dry 1-2 minutes. 3. Completely cover both sides of the pre-cut gasket with sealant. 4. Place coated gasket on flange and assemble mating surfaces with minimal lateral movement.
1For use on rigid machined flanges with less than .015" gap
2OEM approved for use where anaerobic gasket is specified
3Eliminates preformed, pre-cut, paper, rubber and cork gaskets
4Flexes with flanges that move in service
5Withstands temperatures to 300°F (149°C)
