DIRECTIONS: 1. Surfaces should be clean and dry. Cut off tip of cartridge. 2. Attach nozzle, cut at 45 degree angle at desired point and insert cartridge into a caulking gun. 3. Apply a continuous 1/16″ to 1/4″ (2 to 6 mm) bead to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 4. Let dry for one hour then tighten to torque specifications.
Allow 24 hours to fully cure before filling with fluids or returning to service. 5. To reuse package, leave 1/2″ length of material extended from nozzle; cured material will form a protective plug. To reuse, carefully remove the plug and dispense as before. NOTE: Not recommended for use on head gaskets or parts in contact with gasoline.
Permatex’s Ultra Red offers high temperature resistant available today. Ultra Red is a high-performance low-order formulation, outperforming the previous gen. Red RTV. Ultra Red resists temperatures up to 650°F (343°C). This high temperature gasket maker is resistant to high thermal cycling and is sensor-safe, non-corrosive RTV. This chemical gasket maker can be used in replacement of pre-cut gaskets and is ideal for high-temperature applications such as the exhaust manifold, header, turbochargers and slip-fit exhaust parts.
1High temperature performance
2Sensor-safe, non-corrosive, RTV silicone
3Replaces almost any cut gasket
4Resists temperatures up to 650°F (343°C) intermittent